Zoeller 3 float sewage ejector system how to#
Zoeller 3 float sewage ejector system manual#

Take the pump plug out of the electrical socket.Disconnect the plumbing tubes and remove the pump from the pump basin.Replace a broken or malfunctioning sump or sewage ejector float switch by performing the following steps: Retrieve the sump/sewage pump If the pump works well, the float switch is bad. For this, unplug the pump from the switch and plug it in separately. When a sump or sewage pump doesn’t function according to its rated capacity, it is necessary to detect whether the issue is with the pump or the float. Also, the float switch can rust over time and needs replacement. Ensure to clean the sump basin periodically. Debris: Debris in a sump basin can cause the float switch to remain stuck.Use vertical float switches wherever possible check the basement area during every major storm if using tethered float switches. Tethered float switches have a tendency to become stuck on the sump pit’s side walls, resulting in a flooded basement. Float switch type : Vertical float switches are less likely to become stuck.If the sump pump has expelled a lot of air or there is water sloshing all around, the float switch may get stuck on the sides of the sump pit. The motor may not start or won’t be able to stop at certain times if the float switch gets stuck. Stuck float switch: A float switch stuck in the ‘on’ position may be due to the system clogging or the float switch getting tangled up.The wrong switch type may function in the short term, but it is more likely to fail or malfunction. Incorrect design: Float switches are made from different materials or specific mechanical configurations based on their application.Using a load that exceeds the float switch rating can generate heat at the switch contacts, causing it to malfunction.

Zoeller 3 float sewage ejector system manual#

The float switch manual gives the switch’s technical specifications like the cable length, the maximum temperature of operation, and the power rating.

Insufficient rating: A float switch has a rating to indicate the electrical load that it can handle.

Poor maintenance: A poorly maintained float switch can fail over time due to the debris that accumulates on its surface.

The manual contains details regarding the wiring and the various configurations to make the float switch function in the ON and OFF states.

Incorrect configuration: Always refer to the float switch manual and the equipment used in conjunction with it (like a sump or sewage pump).

A float switch can fail due to multiple reasons. If a sump or sewage pump fails, always check the float switch before deciding to replace the pump.

It is an electromechanical switch that turns the basin's sewage pump on or off, depending on the level of the liquid. A sewage pump float switch moves up or down with the liquid level in a sewage basin.

Zoeller 3 float sewage ejector system how to#

Read our article on sump pump float switches for more details on the float switch types applicable in sump pits and how to select them for a particular rating.Ī sewage pump transports waste material from a sewage basin to a septic tank or a sewer system. As the water level decreases within the pit, the float switch enters the ‘open’ state, turning off the pump. When the water level rises to a determined amount, the switch turns on and triggers the sump pump to discharge the water from the pit into a dry well or tank. The switch moves up and down with the water level of the pit and rises as the water level rises. View our online selection of float switches!Ī float switch in a sump pit automatically turns a sump pump on and off.